The pipe rehabilitation process

Step 1: Pipe System Diagnosis
The internal pipe system is mapped, and a plan is implemented for work completion. The piping system is inspected for integrity. After testing for leaks, the pipes are prepared for cleaning.

Etched Single

 

 

 

 

 

Step 2: Pipe Cleaning
Pipes are dried with heated, compressed air. A safe abrading agent is blown through the pipe system, removing rust and corrosion by-products collected in a holding unit for disposal. Compressed air is applied once again to remove fine particles.

Sanded Single

 

 

 

 

 

 

Step 3: Epoxy Lining
Optimal internal pipe surface temperature is created before applying the epoxy coating. Another air pressure leak test is performed. Conditioned air is introduced into the pipe to uniformly distribute the epoxy coating throughout the pipe segment. Following the coating application, continuous controlled air flows through the piping to facilitate epoxy curing.

half coat single

 

 

 

 

 

Step 4: System Reassembly and Final Inspection
After the epoxy coating cures, valves and couplings are refitted. A final leak test and inspection confirms lining integrity. Water quality, volume, and flow tests confirm system functionality.

coated_single

 

 

 

 

 

 

 

To read the full article, click here.

Control the content you see on ConstructionCanada.net! Learn More.
Leave a Comment

Comments

Your email address will not be published. Required fields are marked *